Beskrivning
Klicka här för att ladda ner installationsanvisningar (PDF)
Radium Engineering bränslecellspåfyllningssatser kan användas på alla celler som använder en 6-bult 2,18 “(55 mm) monteringsfläns med bultcirkel. Detta bultmönster används på alla Radium Engineering bränslecellstankar. Skruvgängorna är industristandard 1 / 4 “-28.
Se den här bloggartikeln för mer information om fyllning av bränsleceller.
20-0197-V Direct Mount Fill Neck and Cap
The 20-0197-V Direct Mount Fill Neck and Cap is perfect for filling directly into the fuel cell, as shown. This kit uses the 20-0148-V Fill Neck Cap (included) so filling is quick and simple.
Included:
-Machined and Anodized Aluminum Fill Neck
-Anodized and Laser Etched Aluminum Cap
-Viton Gasket Flange Seal
-Viton O-ring Cap Seal
-Stainless Steel Hardware
20-0495-V Dry Break, 1.5in, Female, Direct Mount, Vented
Designed for direct mounting onto a fuel cell. For mating, a 6-bolt flange with a 2.18″ PCD bolt circle (as found on the FCST) is required. Includes 20-0549-V Dry Break, 1.5in, Female, Vented as well as an aluminum housing, stainless steel hardware, and a gasket. The components, materials, and seals are compatible with all fuel types (unleaded and leaded gasoline, diesel, AV gas, methanol, ethanol, E15, E85, etc.).
Specifications:
Height: 3.43″ (Dry Break to Gasket)
Mate: 20-0496 Dry Break, 1.5in, Male
20-0148-V Fill Neck Cap Only
This is replacement fill neck cap. Compatible with Radium Engineering 20-0197-V.
Included:
-Vented Fuel Fill Cap
-Roll Over Protection
-FKM Viton O-ring
-Tether Hardware
20-0360 Filler Block-Off
This kit blocks off the filler hole on the Radium FCST units.
Included:
-Machined and Anodized Aluminum Blank Plate
-FKM Viton Gasket Flange Seal
-Stainless Steel Hardware
